
- High static pressure for better cooling performance
- Extended speed range | 200 - 2000 rpm (1800 rpm at radiator)
- Low power consumption | 0.11A (0.2A RGB)
- Less vibrations and rubber bumpers
- Improved shelf life
- High quality plain bearing
- PWM for synchronous control of pumps / fans
- Share RGB for synchronous lighting
The Liquid Freezer II RGB combines the efficient and award-winning PWM pump of the Liquid Freezer II with the new RGB fans optimized for static pressure. This gives you a completely new aesthetic with an extremely low noise level and equally low temperatures.
Unlike many of our competitors, we did our best to develop the water pump. The result is greatly reduced hum and increased efficiency. Like the other components, the pump is also PWM controlled. This leads to a significantly lower noise level at low and typical loads, but also to a much lower power consumption, with a maximum of 0.8 W without load, 2.3 W with normal load and a maximum of 4, 8 W at full load for the entire AiO.
Unlike most other all-in-one liquid cooling manufacturers, we rely on 38mm thick radiators with a high fin density. This means that more water can be used in the circuit and the cooling surface can be significantly increased.
Water has a much higher heat capacity than aluminum or copper. This leads to a slower temperature rise and up to 5 C lower in the temporary turbo mode of modern CPUs.
Small fans have a reputation for being particularly loud and short-lived. However, we have developed a quiet and durable diagonal fan especially for Liquid Freezer II and we are 100% convinced that this 40mm fan is just as durable as our other case fans. In the unlikely event of a failure, our customer service team will send you a replacement free of charge and easily, without the need to replace the entire unit.
Highlights ...
* High static pressure for better cooling performance.
* Wide RPM range.
* Low energy consumption.
* High quality plain bearing.
* Share RGB for synchronous lighting.
