Arctic Liquid Freezer II - 280 A-RGB

The Liquid Freezer II A-RGB combines the Liquid Freezer II's critically acclaimed efficient PWM pump with new RGB fans optimized for static pressure. In this way a completely new aesthetic is achieved with extremely low volume and equally low temperatures.

Unlike many of our competitors, we put a lot of effort into developing the water pump. The result is greatly reduced hum and increased efficiency. Like the other components, it is also regulated by PWM. This leads to a significantly lower noise level at low and typical load, but also a much lower power consumption of 0.8 W idle, 2.3 W typical load, and a maximum of 6.78 W at full load. charging for the whole AiO, without lighting.

Unlike most other all-in-one liquid cooling manufacturers, we use 38mm thick radiators with a high fin density. In this way, a greater amount of water can be used in the circuit and the cooling surface can be significantly increased.

Water has a much higher heat capacity than aluminum or copper. This leads to a slower temperature rise and up to 5 ° C lower in the temporary turbo mode of modern CPUs.

Small fans have a reputation for being particularly loud and short-lived. We have developed a quiet and durable diagonal fan especially for Liquid Freezer II and we are 100% convinced that this 40mm fan is as durable as our other case fans. If, contrary to expectations, it should fail, our customer service will send you a hassle-free, no-charge replacement without having to replace the entire unit.

The fan is PWM controlled and can cool your voltage converter and socket area almost inaudibly up to 15 ° C, especially in overclocking scenarios, with insufficient VRM cooling or in cases with poor airflow, allowing continuously high loads. If there is enough VRM cooling, it can be turned off at will.

The long fiber-reinforced EPDM tube of the Liquid Freezer II allows it to be installed in large housings and effectively prevents the coolant from evaporating, so you don't have to worry about refilling the compact water cooling system.

Plus, it hides the RGB and PWM cables from your radiator fans through thoughtful cable management. Simply connect two plugs to the motherboard and save valuable time during installation. In the end, you don't need to hide any more cables and your view is reduced to the essentials.

We highlight ...

* High static pressure to improve cooling performance | 2 mm H2O.
* Extended speed range | 200 - 1900 rpm (1800 rpm at the radiator).
* Less vibrations and rubber dampers | reduced by> 95%.
* PWM for synchronous pump / fan control.
* A-RGB sharing for synchronous lighting.