Arctic P8 PWM 80x80x25

During the development of the new P8 PWM, special emphasis was placed on a focused air stream and therefore high static pressure. The fan ensures extremely efficient cooling, even with increased air resistance. Therefore, the P8 PWM is particularly suitable for use in heat sinks and radiators.

Even at low speeds, the running sound of the new ARCTIC engine is barely noticeable. Due to sinus magnetization, the new motor only creates about 5% of the commutation vibration of a normal DC motor without a filter. Consequently, there is no need for rubber spacers due to the constant and smooth torque of the new motor.

The new Arctic motor has a four times longer service life, thanks to its low coil temperature. A lower 10ºC motor temperature approximately doubles the life of the fan.

Thanks to the 4-Pin connector, the fan rotation speed can be regulated over a wide spectrum through PWM. In this way noise is kept to a minimum, while maximum cooling performance is guaranteed when needed.

Thanks to an alloy / lubricant combination developed in Germany, friction within the bearing is reduced and higher efficiency is achieved. As a result, there is less heat development and less bearing noise, which means you can enjoy a longer life for your fan.

Highlights ...

* 80x80x25mm fan.
* Speed: 200 ~ 3000 RPM.
* Low noise level: 0.3 sone.
* High air flow: 23.4 CFM.
* 4-Pin connection.